Vinyl siding in a humid state grows a film that looks like dirt and behaves like a plant. Florida is the obvious case: long wet seasons, shade from oaks, sprinklers that soak the wall every morning, and air that never quite dries the north side. People rent a 3,000 PSI washer, stand close, and chip the black off. The vinyl chats, the lap lifts, and water runs into the wall. The black is back by August because nothing about the wash changed the damp.
The general method for any house is the siding guide. This page is the mildew version, with the jugs this catalog actually lists. Roof streaks are a different surface, covered in how to soft wash a roof. The tip you rinse with is in nozzle colors.
Dirt, mildew, and the jug that matches
Not every dark wall is the same stain. Pollen and dust sit on the surface and often move with a house wash. Green and black growth is in the texture of the vinyl. Pressure can scrape it, and the pressure it takes is the pressure that drives water up behind the lap.
The Krud Kutter House and Siding concentrate, model 385464, is the bleach-free gallon whose listing names vinyl, wood, brick, aluminum, and stucco, with a 3 to 5 minute dwell. Use it for dirt on those surfaces. The verdict on that product is blunt about living stain: it does not replace a mildew cleaner when the growth is alive. If the wall is black in the shade, this jug is the wrong promise.
The 30 SECONDS Outdoor Cleaner gallon, model 1G30S, says mix one to one with water and names siding among decks, concrete, and fences. That is the organic-stain product to read for a mildew wall. The listing does not, in the features we checked, authorize the pressure-washer pump. Put it in a pump sprayer. Do not mix it with ammonia or acids. Rinse plants before and after.
The 30 SECONDS pressure washer concentrate is the other bottle. The listing says it is made for the tank, that the formula is powered by bleach, and that it makes up to 20 gallons. That is the brand’s claim for this SKU only. If you use it, you are using a bleach mix inside the washer, on the soap setting, not with a 15-degree tip an inch off the vinyl. Do not combine it with the Krud Kutter jugs. The same listing says the products are manufactured in the USA using US and imported parts. That sentence is not an all-or-virtually-all Made in USA claim, and this page does not add the badge.
The Krud Kutter multi-purpose gallon is the one-jug compromise for siding, concrete, and vehicles. It is still bleach-free on the listing. It is still not the mildew answer when the stain is alive.
Humidity is the reason it returns
A clean wall in June can be speckled by September when the dew point stays high and the shrubs hold moisture against the vinyl. Irrigation heads aimed at the house are a mildew machine. So is a downspout that dumps on the foundation and splashes the first course. Cleaning does not seal vinyl. There is no year-count on this page because nobody honest can give you one without knowing the shade and the sprinklers.
What you can change is the splash and the light. Move a head. Trim what touches the wall. Those are not affiliate products. They are why a second wash is maintenance, like mowing, and not a sign the first wash failed.
Do the work in the morning or on a cloudy day so the mix does not flash-dry on hot vinyl. Hot vinyl plus dried chemical is a streak you then try to remove with more pressure. That is the loop to avoid.
Apply low, rinse down
Soak the plants until water runs out of the soil. Cover outlets, dryer vents, and light fixtures. Skip the panel and anything under the service drop. The siding guide is the longer version of that warning, including lead paint on older wood. This page is vinyl. Painted wood next to it is not vinyl.
Apply from the bottom of the wall upward, in a wet coat, so you are not dragging cleaner through a dry dirty section and leaving tiger stripes. A pump sprayer is the right tool for the outdoor-cleaner gallon. The BE 12-volt sprayer or the NorthStar 26-gallon sprayer is the right tool when you want a tank instead of a hand pump, and when you have confirmed the chemical can sit in that pump. They are not pressure washers. Their listings are 2.0 GPM and 2.2 GPM at 12 volts. No PSI was in the features we checked.
Wait the time on the label. Mist a section that starts to dry. Do not let it dry and then blast it.
Rinse from the top down so dirty water leaves a finished section. Point the tip slightly down. A lap that chatters is lifting. Back up until it stops. Windows can be rinsed. A focused jet at a seal or a screen pushes water and tears mesh. Take screens down or skip them.
The washer and the tip
You do not need 3,000 PSI on vinyl. An electric washer is enough for the rinse if the outlet is near the wall. The electric guide is the corded list. A gas cart from the gas guide is fine only with a wide tip and distance. The PSI and GPM guide is the range: soap does the work, the fan only rinses.
On the Simpson sets, white is 40 degrees and green is 25. White is the default. Green is as narrow as most siding should see, and only while the wand is moving. Yellow, 15 degrees, is a concrete tip. Red is a cutting stream. Black is the soap tip, which is the low-pressure setting if you are using a tank product the label allows. The colors are explained in the nozzle guide, and the sets themselves are the Simpson 80145 at orifice 3.0 and the Simpson 80146 at orifice 4.0. Match the orifice to the pump. Do not “upgrade” to the larger hole because the color looks the same.
First-floor walls are easier with a short wand. The Simpson 80149 is 16 inches, cold water, 3,600 PSI, M22 to a 1/4-inch quick connect. It is a replacement lance, not a way to reach a second story.
Second story, from the dirt
A ladder plus a trigger is a fall. The Simpson 80470 extends from 6 to 18 feet, includes a harness, and is rated to 4,000 PSI, 8.0 GPM, cold water, 140°F. The rating is a ceiling. The tip is still a wide fan. A long wand wants to climb. The harness is there so your back is not the only thing holding it. If you cannot keep the tip pointed down the wall, stop.
Do not stand the telescoping wand against the vinyl and walk. Distance is what keeps the lap down. Overhead lines are not a target. If the wand can reach a service drop, you are in the wrong place.
When the wall dries
Look for lifted panels, drips at windows, and green left under the eaves. A second chemical pass on a remaining patch is better than stepping closer. Rinse the plants again. Flush a soap tip with clear water if you used the tank.
If water showed up inside a window or an outlet, stop. Find the opening before you wet that wall again. A clean exterior with a damp cavity is a loss.
In a humid summer, plan on the shady wall again next year. Write down which jug you used and how long it sat, so the next wash starts from the label instead of from a closer nozzle.
